Joint-It Simple Paving Jointing Compound Mortar 20kg - Grey

Joint It Jointing Mortar For Slabs / Paving - Dark Grey - 20kg

Joint-It Simple is a ready-mixed, permeable, jointing compound that can be applied in all weathers.

Product Information:

STEP 1: PREPARATION
Make sure all joints are clear of any dirt, oil, grease and debris,
Make sure all joints are cleaned out to a minimum depth of 20mm and a width of at least 3mm,

STEP 2: PRE-WET
Soak the area well prior to opening and spreading Joint-It Simple,

STEP 3: POUR
Open the tub and immediately pour Joint-It Simple onto the area,

STEP 4 : WORK-IT-IN
Using a squeegee or street broom, spread Joint-It Simple evenly,
Work-it-in so that it goes deeply into the joints and is well compacted,

STEP 5: ADD MORE WATER
Add more water sparingly to help Joint-It Simple flow into the paving joints,
Work diagonally across the joints to make sure that Joint-It Simple has penetrated all of the paving joints,

STEP 6: FINAL CLEANING
Clean the surface carefully with a fine-hair broom so that all Joint-It is removed,
Always sweep diagonally across the joints,
Any residual materials can be swept off after application using a soft broom.

Joint It Jointing Mortar For Slabs / Paving - Neutral - 20kg

Joint-It Simple is a ready-mixed, permeable, jointing compound that can be applied in all weathers.

Product Information:

STEP 1: PREPARATION
Make sure all joints are clear of any dirt, oil, grease and debris,
Make sure all joints are cleaned out to a minimum depth of 20mm and a width of at least 3mm,

STEP 2: PRE-WET
Soak the area well prior to opening and spreading Joint-It Simple,

STEP 3: POUR
Open the tub and immediately pour Joint-It Simple onto the area,

STEP 4 : WORK-IT-IN
Using a squeegee or street broom, spread Joint-It Simple evenly,
Work-it-in so that it goes deeply into the joints and is well compacted,

STEP 5: ADD MORE WATER
Add more water sparingly to help Joint-It Simple flow into the paving joints,
Work diagonally across the joints to make sure that Joint-It Simple has penetrated all of the paving joints,

STEP 6: FINAL CLEANING
Clean the surface carefully with a fine-hair broom so that all Joint-It is removed,
Always sweep diagonally across the joints,
Any residual materials can be swept off after application using a soft broom.

Joint It Jointing Mortar For Slabs / Paving - Black - 20kg

Joint-It Simple is a ready-mixed, permeable, jointing compound that can be applied in all weathers.

Product Information:

STEP 1: PREPARATION
Make sure all joints are clear of any dirt, oil, grease and debris,
Make sure all joints are cleaned out to a minimum depth of 20mm and a width of at least 3mm,

STEP 2: PRE-WET
Soak the area well prior to opening and spreading Joint-It Simple,

STEP 3: POUR
Open the tub and immediately pour Joint-It Simple onto the area,

STEP 4 : WORK-IT-IN
Using a squeegee or street broom, spread Joint-It Simple evenly,
Work-it-in so that it goes deeply into the joints and is well compacted,

STEP 5: ADD MORE WATER
Add more water sparingly to help Joint-It Simple flow into the paving joints,
Work diagonally across the joints to make sure that Joint-It Simple has penetrated all of the paving joints,

STEP 6: FINAL CLEANING
Clean the surface carefully with a fine-hair broom so that all Joint-It is removed,
Always sweep diagonally across the joints,
Any residual materials can be swept off after application using a soft broom.

Sandstone Paving Slab - Grey - 600mm x 600mm x 22mm

Product Information:

- Single slab

- Slab size: 600mm x 600mm x 22mm

- Specially selected for it's low thickness

- The 22mm calibrated thickness of this paving slab makes it perfectly suitable for large areas or for patios where depth is at a premium

- Grey sandstone contains natural iron which may oxidise and show as brown markings, this is inherent in the stone itself and is not a fault

O'Brien Post Mix 20kg Bag

O’Brien Cement Post Mix is a simple to use rapid setting concrete mix for fixing posts in the ground. It is pre-mixed and blended and contains cement, dried aggregates and admixtures. The cement used is O’Brien Cement manufactured in Ireland and conforms to I.S EN 197-1 2011.

Product Information:

1. 1. Dig a hole to required size for post, half fill the hole with water and place the post in the hole,
2. 2. Tip the pre-mixed aggregate uniformly into the hole around the post, until it is above the level of water,
3. 3. If any dry powder remains visible at this stage, add additional water until absorbed by the material,
4. 4. Adjust the post into position and support appropriately until material set occurs, which takes approximately 10 minutes.

Cement 25kg Supplied in a Weatherproof Plastic Bag

O'Brien premium grade cement for jobs which require higher strength cement, such as screeds, concrete, plastering and mortar, this premium grade product is ideal.

Product Information:

- Smooth, uniform finish, and impressive drying performance.

- Premium grade O'Brien cement with 42.5N strength which offers exceptional performance.

- Supplied in a plastic based bag.

Onduline Corrugated Roofing Sheet Clear - 2mts x 950mm x 3mm

Clear polycarbonate corrugated Onduline Sheets

Product Information:

- Length: 2000mm

- Width: 950mm

- Thickness: 3mm

- Cover width: 855mm

- Corrugation height: 38mm

- Corrugation width: 95mm

- Recommendation: 30 fixings per sheet

- Colour: Clear

25mm x 38mm Roofing Batten Treated - 4.8 metres

Roofing batten type A produced in Sweden BS 8417 Certified.

Product Information:

- Country of origin: Sweden

- Species: Spruce

- Grade: BS 8417 certified

- Moisture content: Kiln dried (18% approx.)

- Treatment: UC2

- Colour: Green

- Surface finish: Sawn

- Machined from / size: 25mm x 38mm

- Length: 4.8mts

Aggregate (All In) Jumbo Sling Bag 900kg approx

Delivered by one of our crane vehicles in a large nylon bag.

Product Information:

- Natural product hence colour variations can occur.

- This product consists of plain sand and 20mm limestone chippings mixed!

- Ideal for forming foundations and hardstand areas.

- Reinforceme nt mesh may be necessary for some applications.

- Delivered by one of our crane vehicles in a 900kg nylon bag.

Gutter / Guttering Half Round Profile 5.0mts

5 Metre length of Half Round Profile Gutter.

Product Information:

- Manufacturer: Freefoam.

- Profile: Half round.

- Size: 112mm.

- Length: 5.0mts.

Gutter / Guttering Half Round Profile Stop End Outlet

Half Round Gutter Stopend Outlets can be used at the end of a gutter to allow a downpipe to be fitted for the drainage of water.

Product Information:

- Manufacturer: Freefoam.

- Profile: Half round.

- Fitting: Gutter stop end outlet.

- Size: 112mm.

Downpipe For Gutter / Guttering Round Profile 4mts

4 Metre length of Round Profile Downpipe.

Product Information:

- Manufacturer: Freefoam.

- Profile: Round.

- Size: 68mm.

- Length: 4mts.