12 x 130mm Thunderbolt Hex Head Masonry Anchor Bolt

25mm Insulating Polystyrene Sheet 2400mm x 1200mm

Product Information:

- Easy to cut to size using a sharp knife.

- Very cost effective and entirely rotproof when correctly installed.

- Effectively insulates wall areas which minimises heat loss and reduces energy bills.

- Lightweight and easily handled for easy installation.

- Can be used underneath concrete sla bs in solid ground floor constructions, and also above or below damp proof membranes.

- Manufactured from expanded polystyrene board.

- Sheet size: 2400mm x 1200mm.

9mm OSB3 External Grade Composite Board - 2400mm x 1200mm

Oriented Strand Board (OSB) is an engineered wood based panel board where strands of wood are laid in cross-oriented layers and glued with an ECO resin. This results in a strong board that resists moisture, is versatile, and suitable for structural use in humid conditions.

Product Information:

- OSB3: Suitable for fibreglass roofing.

- Also known as Sterling Board

- Size: 2400mm x 1200mm.

- Thickness: 9mm

25mm x 50mm BS5534 Engineered Roofing Batten Treated - 4.8 Metres

(Special Offer: £0.58 + VAT per metre)

Roofing batten engineered produced in Sweden BS 5534 Certified.

Product Information:

- Country of origin: Sweden

- Species: Spruce

- Grade: BS 5534 certified

- Moisture content: Kiln dried (18% approx.)

- Treatment: UC2

- Colour: Gold

- Surface finish: Sawn

- Machined from / size: 25mm x 50mm

Thunderbolt Masonry Fixing - Priced Per Bolt

Thunderbolt™ is the original self tapping masonry anchor with the power to be used on a whole range of construction materials such as concrete, brick and stone.

It is a single piece, non expansion anchor, meaning that it does not require a wall plug or resin, and therefore makes it an ideal solution for close to edge fixing applications.

The threaded anchor and self tapping action allow for a safe strong anchorage, with the substrate becoming the nut to the bolt.

Installation is quick and easy, making it the ideal general purpose anchor which is versatile even in a temporary situation.

Product Information:

- Drill a hole the same size as the Thunderbolt™ into the masonry, ensure the hole is a little deeper than the bolt to allow for dust.

- Remove any loose debris from the hole.

- Screw in the Thunderbolt™ with a suitable driver and apply a slight downward pressure to start the self tapping action.

- Tighten the Thunderbolt™ to secure the fixture firmly in place.

UC3 Treated Sawn Timber - 100mm x 100mm - 3 Metres

Treated 4" x 4" Sawn green fence post.

Product Information:

- Country of origin: UK

- Species: Spruce

- Surface finish: Rough sawn

- Treatment: UC3

- Colour: Green

- Machined from / size: 100mm x 100mm

- Length: 3mts

O'Brien Post Mix 20kg Bag

O’Brien Cement Post Mix is a simple to use rapid setting concrete mix for fixing posts in the ground. It is pre-mixed and blended and contains cement, dried aggregates and admixtures. The cement used is O’Brien Cement manufactured in Ireland and conforms to I.S EN 197-1 2011.

Product Information:

1. 1. Dig a hole to required size for post, half fill the hole with water and place the post in the hole,
2. 2. Tip the pre-mixed aggregate uniformly into the hole around the post, until it is above the level of water,
3. 3. If any dry powder remains visible at this stage, add additional water until absorbed by the material,
4. 4. Adjust the post into position and support appropriately until material set occurs, which takes approximately 10 minutes.